|
|
Table Of Contents
Obtaining Documentation, Obtaining Support, and Security Guidelines
About this Guide
Revised: May 30 2007, OL-7824-06This preface describes who should read the SCE 2000 4xGBE Installation and Configuration Guide , how it is organized, and its document conventions.
This installation guide explains the initial hardware installation and basic configuration procedures for the SCE 2000. It contains procedures for unpacking and installing the device and performing basic configuration via the setup wizard. After completing the installation and basic configuration procedures covered in this guide, you will then use the appropriate companion publications to more completely configure your system.
This guide contains instructions on how to install and run the SCE 2000 platform. This guide assumes a basic familiarity with telecommunications equipment and installation procedures.
This introduction provides information about the following topics:
•
Audience
•
Audience
This guide is for the networking or computer technician responsible for installing and configuring the SCE 2000 platform on-site. To use this publication, you should be familiar with telecommunications equipment and installation procedures, as well as electronic circuitry and wiring practices. You should also have experience as an electronic or electromechanical technician.
Organization
The major sections of this guide are as follows:
Table 1
Chapter
Title
Description
Chapter 1
This chapter provides a brief introduction to Cisco Service Control.
Chapter 2
This chapter provides a hardware overview of the SCE 2000 platform.
Chapter 3
This chapter describes the possible deployment topologies of the SCE 2000 and explains how various aspects of the topology determine the configuration of the system.
Chapter 4
This chapter explains how to install a SCE 2000 platform in a rack or in a general tabletop installation and how to install or replace the power supply units and fan modules.
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
This chapter explains how to connect the SCE 2000 platform to a local console and perform the initial system configuration via the setup wizard that runs automatically.
Chapter 6
This chapter provides instructions for cabling the Gigabit Ethernet ports for both one and two SCE 2000 topologies, and for configuring Gigabit Ethernet (GBE) interface parameters. In a topology utilizing two SCE 2000 s (cascade), this includes the cascade ports as well as the line ports.
Chapter 7
This chapter describes how to start up the SCE 2000 platform, reboot, and shutdown. It also describes how to manage configurations.
Chapter 8
This chapter provides basic system startup troubleshooting information.
Appendix A
This appendix explains how to install the optional external optical bypass module.
Related Publications
Your SCE 2000 platform and the software running on it contain extensive features and functionality, which are documented in the following resources:
•
–
–
Note
•
•
•
–
–
–
–
•
–
–
Obtaining Documentation, Obtaining Support, and Security Guidelines
For information on obtaining documentation, obtaining support, providing documentation feedback, security guidelines, and also recommended aliases and general Cisco documents, see the monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Posted: Fri Aug 24 07:19:40 PDT 2007
All contents are Copyright © 1992--2007 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.
