cc/td/doc/product/wanbu/bpx8600/9_2
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table Of Contents

Configuration, Introduction

Introduction

Configuration Procedures


11

Configuration, Introduction


Introduction

Detailed configuration information is provided in this part of the document. A summary of the configuration instructions is provided in the Quickstart instructions at the front of the manual, in PART 2, Quickstart.

For additional information on the BPX switch, including card descriptions and additional information on configuration, refer to the Cisco BPX 8600 Series Reference. For a description of the commands used to operate a BPX switch, refer to the Cisco WAN Switch Command Reference. Refer to the Cisco WAN Manager manuals for information on network management.

Configuration Procedures

shows the sequence of operations followed during the configuration of the BPX switch. A summary of this sequence is as follows:

Chapter 12, , provides preliminary configuration instructions for the BPX switch including basic node configuration.

As a minimum, the nodes need to be configured with name (cnfname), date (cnfdate), time (cnftime), time zone (cnftmzn), and trunks upped (uptrk) and added (addtrk or addshelf), as applicable. In addition, instructions are provided for configuring the nodes for operation with the Cisco WAN Manager.

The following chapters provide information and configuration examples for various types of ATM connections:

Chapter 13,

Chapter 14,

Chapter 15, Configuration, BXM Virtual Trunks

Chapter 16,

Chapter 17, SONET APS, Configuration

Chapter 18,

Chapter 19, Configuration General, MPLS on BPX Switch

Chapter 20,

Chapter 21, MPLS CoS with BPX 8650, Configuration

Chapter 22,

Figure 11-1 Configuration Sequence


hometocprevnextglossaryfeedbacksearchhelp

Posted: Tue May 10 21:37:18 PDT 2005
All contents are Copyright © 1992--2005 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.