cc/td/doc/product/wanbu/bpx8600/8_4
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table of Contents

About this Manual

About this Manual

This publication provides installation instructions for the BPX.

Cisco documentation and additional literature are available in a CD-ROM package, which ships with your product. The Documentation CD-ROM, a member of the Cisco Connection Family, is updated monthly. Therefore, it might be more up to date than printed documentation. To order additional copies of the Documentation CD-ROM, contact your local sales representative or call customer service. The CD-ROM package is available as a single package or as an annual subscription. You can also access Cisco documentation on the World Wide Web at http://www.cisco.com, http://www-china.cisco.com, or http://www-europe.cisco.com.

What's in This Publication?

This publication is organized as follows:

Chapter 1

Introduction

Provides a brief introduction to the document, including a flow diagram that shows which procedures are applicable to the various options, Stratm Cabinet or Customer Cabinet, ac cabinet or dc cabinet

Chapter 2

Installation, Preliminary

Provides preliminary installation instructions for the BPX .

Chapter 3

Installation, with a Cisco Cabinet

This chapter provides installation steps for the mechanical placement of a BPX shelf in a standard STRATM cabinet. This cabinet provides rear rails at a 19.86 inch (50.5 cm) setback from the front of the cabinet.

Chapter 4

Installation, with Customer Cabinet

This chapter provides installation steps for the mechanical placement of a BPX shelf in a standard 19-inch customer supplied equipment cabinet or rack with a rear rail setback at 30 inches.

Chapter 5

Installation, DC Shelf Initial Setup

This chapter describes how to make the DC power connections.

Chapter 6

Installation, AC Shelf Initial Setup

This chapter explains how to install the AC power supply tray, power supplies, and make AC power connections.

Chapter 7

Finishing the Installation

This chapter explains how to install the BPX cards, connect line and trunk cables, connect peripherals, connect to a network management station, initial power up, and initial configuration.

Chapter 8

T3/E3 Cable Management Tray

This appendix provide details on the peripherals used with the BPX including printers and modems.

Appendix A

Cisco Cabinet Dimensions

Illustrates typical cable management and space requirements for various system configurations in the STRATM cabinet. It also lists the height of StrataCom components in inches, centimeters, and rack-mount units (RMUs).

Appendix B

BPX Cabling Summary

This appendix provides details on the cabling required to install the BPX node.

Appendix C

BPX Peripherals

This appendix provide details on the peripherals used with the BPX including printers and modems.

Related Documentation

Conventions

This publication uses the following conventions to convey instructions and information.

Command descriptions use these conventions:

Examples use these conventions:


Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in this manual.
TimeSaver Means the described action saves time. You can save time by performing the action described in the paragraph.
Caution Means reader be careful. In this situation, you might do something that could result in equipment damage or loss of data.
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, you must be aware of the hazards involved with electrical circuitry and familiar with standard practices for preventing accidents. (To see translated versions of this warning, refer to the Regulatory Compliance and Safety Information that accompanied your equipment.)

hometocprevnextglossaryfeedbacksearchhelp
Posted: Thu Jan 18 01:20:38 PST 2001
All contents are Copyright © 1992--2001 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.