|
This document provides installation instructions for the BPX.
For additional information on the BPX, including card descriptions and additional information on configuration, refer to the BPX Reference. For a description of the commands used to operate a BPX, refer to the Command Reference. Refer to the System Overview for system and network information. Refer to the StrataView Plus manuals for information on network management.
Figure 1-1 shows the sequence of operations followed during the installation of the BPX. A summary of this sequence is as follows:
The BPX shelves are either AC or DC powered. At the completion of the procedures in Chapter 3 or Chapter 4, the installer is directed to the appropriate power setup and connection chapter:
The remaining procedures are common and the installer is directed to the final setup and configuration procedures in:
An optional cable management tray and optional BXM T3/E3 cable management brackets are available for use with T3/E3 BXM cards. The brackets are for use with cards set up as non-redundant (single cables rather than Y-cabling). The tray is designed primarily for use in a mid-mount open rack configuration. Instructions for installing the optional tray are provided in:
Contact Cisco Customer Service for more information.
Posted: Thu Jan 18 01:19:53 PST 2001
All contents are Copyright © 1992--2001 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.