Installation with Customer Cabinet

Table Of Contents

Installation with Customer Cabinet

Installing a BPX Switch, Rear Rail Setback at 30-Inch

Preliminary Procedure:

4

Installation with Customer Cabinet

This chapter provides installation steps for the mechanical placement of a BPX switch shelf in a standard 19-inch customer supplied equipment cabinet or rack with a rear rail setback at 30 inches.

Before proceeding to this chapter, the procedures should be completed, in:

• Chapter 2,

Installing a BPX Switch, Rear Rail Setback at 30-Inch

The steps in this procedure apply to a BPX switch shelf that is being installed in a customer supplied cabinet with rear vertical rails located at a setback of approximately 30 inches from the front.

If the BPX switch shelf is DC-powered, the DC Power Entry Modules are factory-installed in the lower portion of the rear of the BPX switch shelf itself. Locate the DC Power Entry Module(s) and make sure it/they are equipped as ordered. If the BPX switch shelf is AC-powered, an AC Power Assembly will be installed below it.

Preliminary Procedure:

Proceed as follows to install the BPX switch shelf, referring to through , and to either for DC powered systems or for AC powered systems. shows the location of the rear located third rails in a customer supplied cabinet and of the corresponding adjustable plates and support brackets on the BPX switch shelf.

Step 1 With one person on each side of the BPX switch shelf, lift the pallet tray and BPX switch shelf positioning the slots at the rear of the pallet tray over the locating tabs on the spacer bracket ( ).

Step 2 Slide the BPX switch shelf back over the support brackets and into place.

Step 3 Secure the BPX switch shelf to the front rail using 8 each #10-32 screws.

Note European installation may use a size M6 metric screw.

Step 4 Locate the two rear support brackets and adjustable plates in the miscellaneous parts kit.

Step 5 Position the adjustable plates with the tabs in the three punchouts facing up as shown in .

Figure 4-1 BPX Switch Aligned with Temporary Support Brackets and Spacer Bar

Step 6 Align the top and bottom holes in the adjustable plates with corresponding holes in the side panel of the BPX switch shelf. (The bottom of the plates should be approximately aligned with the bottom of a DC powered BPX switch shelf. They should be extended below the bottom of an AC powered BPX switch shelf so that the AC Power Supplies can be secured to the shelf.)

Step 7 Secure one each adjustable plate to each side of the BPX switch shelf using (2) each #10-32 machine screws and flat washers.

Step 8 Attach a rear support bracket to each one of the adjustable plates with 2 each #10-32 screws and washers. Do not tighten yet.

Step 9 Secure the support brackets to the rear located vertical rails using 2 each #10-32 screws. You may have to lift the BPX switch shelf slightly to align the holes in the bracket to the holes in the rack.

Step 10 Tighten the screws attaching the support bracket to the adjustable plate.

Step 11 Slide a cable strap over each of the three tabs on the support brackets.

Step 12 Remove the temporary support bracket and spacer bracket from the front of the cabinet.

Step 13 If this is a DC powered shelf, proceed to Chapter 5, .

Step 14 If this is an AC powered shelf, proceed to Chapter 6, .

Figure 4-2 BPX Switch with Rear Rail Mounting at Setback of 30 Inches

Figure 4-3 Rear Mounting Brackets, Detail

Figure 4-4 Rear Mounting Brackets, with 30 Inch Rear Rail Setback (DC Systems)

Figure 4-5 Rear Mounting Brackets, 30 Inch Rear Rail Setback (AC-Powered Systems)