cc/td/doc/product/lan/cat6000/6000hw
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table Of Contents

FlexWAN Module


FlexWAN Module


This chapter describes the FlexWAN module.

The FlexWAN module (WS-X6182-2PA) is installed in a switch that has a supervisor engine with an MSFC and a PFC. (See Figure 4-1.) The MSFC, in conjunction with the FlexWAN module, provides multiprotocol routing support with full Internet route connectivity for speeds ranging from serial RS-232 to OC-3. The FlexWAN module can accept up to two Cisco 7200/7500 WAN port adapters, which deliver WAN consolidation and extend QoS and traffic-management capabilities over WAN segments. The FlexWAN module supports ATM and Packet-over-SONET (POS) OC-3 links and channelized, multichannel, and clear channel port adapters. Table 4-1 lists the supported adapters.

Table 4-1 WS-X6182-2PA Supported Cisco 7200 Series and Cisco 7500 Series
WAN Port Adapters 

T1/E1
T3/E3 and STM-1
HSSI
ATM
Packet over SONET

PA-4T+

PA-T3

PA-H

PA-A3-T3

PA-POS-OC3MM

PA-8T-V35

PA-T3+

PA-2H

PA-A3-E3

PA-POS-OC3SMI

PA-8T-232

PA-E3

 

PA-A3-OC3MM

PA-POS-OC3SML

PA-8T-X21

PA-2T3

 

PA-A3-OC3SMI

 

PA-MC-4T1

PA-2T3+

 

PA-A3-OC3SML

 

PA-MC-8T1

PA-2E3

     

PA-MC-8E1/120

PA-MC-T3

     
 

PA-MC-E3

     
 

PA-MC-STM-1

     

For more information about the MSFC and PFC, refer to the Catalyst 6500 Series Switch Software Configuration Guide.


Note Throughout this publication, except where noted, the term MSFC refers to both MSFC and MSFC2, and the term PFC refers to both PFC and PFC2.



Note To use the FlexWAN module, you must have a supervisor engine with an MSFC and a PFC. You configure the FlexWAN module through the MSFC.


The STATUS LED on the FlexWAN module front panel (see Figure 4-1) indicates the status of the FlexWAN module. Table 4-2 describes the LED operation.

For information on FlexWAN module hardware and software requirements and port adapter installation and configuration, refer to the Catalyst 6000 Family FlexWAN Module Installation and Configuration Note.

Figure 4-1 FlexWAN Module Front Panel (WS-X6182-2PA)

Table 4-2 FlexWAN Module STATUS LED 

Color/State
Description

Green

All diagnostics pass; the module is operational.

Orange

The module is booting or running diagnostics.

 

An overtemperature condition has occurred. (A minor temperature threshold has been exceeded during environmental monitoring.)

Red

A diagnostic test has failed; the module is not operational.

 

An overtemperature condition has occurred. (A major temperature threshold has been exceeded during environmental monitoring.)



hometocprevnextglossaryfeedbacksearchhelp

Posted: Thu Dec 30 00:08:20 PST 2004
All contents are Copyright © 1992--2004 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.