Installing a Service Control Application

Table Of Contents

Installing a Service Control Application

Advanced Configuration of the SCE Platform

Loading and Activating a Service Control Application

Installing a Service Control Application

• Advanced Configuration of the SCE Platform

• Loading and Activating a Service Control Application

Advanced Configuration of the SCE Platform

After you have installed your SCE 2000 platform hardware, checked all external connections, turned on the system power, allowed the system to boot up, and performed the initial system configuration, you are ready to install the Service Control application. However, before you install the application, you might need to perform more complex configurations, which are beyond the scope of this publication.

For further information on system and interface configuration, refer to the following documents:

•Cisco Service Control Engine (SCE) Software Configuration Guide

•Cisco Service Control Engine (SCE) CLI Command Reference

Loading and Activating a Service Control Application

The SCE 2000 platform provides the basic functionalities of Service Control analysis and enforcement. A Service Control solution requires that a Service Control application be loaded into the platform, to take advantage of the unique SCE platform capabilities.

Loading and activating an application includes the following stages:

•Downloading the application provided as an SLI file to the SCE 2000 disk.

•Activating the application.

•Configuring the application.

The detailed procedure of how to perform these operations is not specified and described in this manual. For further details, refer to the following documentation:

•Service Control Application for Broadband User Guide

•Service Control Application for Broadband Reference Guide