New Features in Release 12.0(30)S
Any Transport over MPLS
Any Transport over MPLS (AToM): Layer 2 QoS for the Cisco 12000 Series Router (Quality of Service)
Any Transport over MPLS (AToM): Remote Ethernet Port Shutdown
Any Transport over MPLS (AToM) Sequencing Support
Cisco IOS IPv6 Configuration Library
Cisco IOS Software Configuration for the Cisco 10720 Internet Router
Control Plane Policing
IMA Dynamic Bandwidth
Configuring Multicast VPN Inter-AS Support
Layer 2 Virtual Private Network Interworking
Layer 2 Local Switching
Layer 2 Tunnel Protocol Version 3
Loopback Mode Detection through OAM
Maximum Mask Aggregate Output NetFlow
MPLS Label Distribution Protocol MIB
MPLS LDP Autoconfiguration
MPLS LDP-IGP Synchronization
MPLS LDP Session Protection
MPLS Traffic Engineering (TE): Path Protection
MPLS TE: Link and Node Protection, with RSVP Hellos Support (with Fast Tunnel Interface Down Detection)
MPLS VPN: MIB Support
MPLS VPNs over IP Tunnels
Multilink Frame Relay (FRF.16.1)
Multirouter APS for the Cisco 12000 Series ISE ATM Line Cards
OAM Segment Endpoint
OSPF Sham-Link MIB Support
Performance Route Processor (PRP) Software Configuration in Cisco 12000 Series Internet Routers
PIM RPF Vector
Pseudowire Emulation Edge-to-Edge MIBs for Ethernet and Frame Relay Services
QoS: ATM CLP-Based Queue Limit
QoS: Partial Support for Ingress Hierarchical Policing for the Cisco 12000 4-port Gigabit Ethernet ISE Line Card
QoS: Match ATM OAM
Resilient Packet Ring Feature Guide
This document describes how to configure RPR on supported Cisco routers.
Spatial Reuse Protocol Feature Guide
This publication is also known as the Dynamic Packet Transport Feature Guide.
Stacked VLAN Processing
All contents are copyright © 1992--2007 Cisco Systems, Inc. All rights reserved.
Important Notices
and
Privacy Statement
.