cc/td/doc/solution/dialvoic/pstngw
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table Of Contents

Cisco PSTN Gateway Solution Commonly Performed Tasks

Installation Tasks

Using Cisco Signaling Link Terminal

Using Command Line Interfaces

Using Dial Plans

Using Graphical User Interfaces

Using Network Management

Additional Tasks


Cisco PSTN Gateway Solution Commonly Performed Tasks


Updated March 2003
Current through PSTN Gateway Solution Release 5

Commonly used PSTN Gateway Solution tasks are listed below. For additional information about using the PSTN Gateway Solution, view the PSTN Gateway Solution user documentation:

http://www.cisco.com/univercd/cc/td/doc/solution/dialvoic/pstngw/index.htm

Installation Tasks

Configuring the Cisco MGC Software Release 9.1(5)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/3ins_cfg.htm

Configuring the Cisco MGC Software Release 9.2(2)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/3ins_cfg.htm

Configuring the Local Area Network Switch

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/5ins_lan.htm

Installing Cisco MGC Software Release 9.2(2)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/swin8_92.htm

Installing the Sun Solaris 8 Operating System

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/swin8_os.htm

Installing Sun Solaris 2.6 Operating System

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/1inst_os.htm

Installing Cisco MC Software Release 9.1(5)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/2inst_74.htm

Migrating to Solaris 8 and Cisco MGC 9.2(2)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/swin8_mg.htm

Preparing for Sun Solaris Operating System and Cisco MGC Software Installation

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/prep_ins.htm

Upgrading the Cisco Media Gateway Controller to Software Release 9.1(5)

http://cco/univercd/cc/td/doc/product/access/sc/rel9/swinstl/4ins_upg.htm

Using Cisco Signaling Link Terminal

Configuring the Session Manager and RUDP

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t1/ftsltdes.htm#xtocid12

Monitoring and Maintaining the Cisco SLT

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t1/ftsltdes.htm#xtocid14

SS7 Four-Link Support for Cisco SLT

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xa/122xa_2/ft_4lnk.htm

Upgrading Cisco SLT

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel7/soln/das/upgrade/slt.htm

Verifying the Session Manager and RUDP Configuration

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t1/ftsltdes.htm#xtocid13

Using Command Line Interfaces

Adding an MGCP signaling service

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/prvgde/r9mmlchg.htm#xtocid26

Configuring E1 with Drop and Insert

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm#12994

Configuring the MTP2 variant

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm#20519

Deleting a dial plan

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/mmlref/mmlref.htm#xtocid11

Deleting an existing point code

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/mmlref/mmlref.htm#xtocid16

Disabling outgoing COT

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/mmlref/mmlref.htm

Performing manual switchover

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/mmlref/mmlref.htm#xtocid84

Starting a purge of the DNS cache

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/mmlref/mmlref.htm#xtocid74

Verifying the Ethernet Interface Configuration

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120xr/0219nomd.htm#20519

Using Dial Plans

Provisioning conditional routing

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/dplan/dp_mmlch.htm#xtocid60

Using Graphical User Interfaces

Configuring SS7 signaling services

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/prvgde/r9gui.htm#xtocid6

Determining the software version of BAMs

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/bams3/b3ch4.htm#xtocid49

Using Network Management

Configuring Network Devices for Management

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel7/cmnmgr/rambelem.htm

Additional Tasks

Failover daemon on the standby Cisco MGC is not reachable

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/omts/r9_ch8.htm#xtocid76

Initializing the Call Screening Database

http://www.cisco.com/univercd/cc/td/doc/product/access/sc/rel9/swinstl/3ins_cfg.htm#1470893


hometocprevnextglossaryfeedbacksearchhelp

Posted: Mon Aug 29 16:10:10 PDT 2005
All contents are Copyright © 1992--2005 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.