|
The following sections summarize the steps for installing and starting Design Studio:
For more detailed information, see the Design Studio User Guide.
Design Studio requires the following:
To install Design Studio, perform these steps:
Step 2 Insert the Design Studio CD-ROM into your CD-ROM drive.
If auto-start is enabled on your computer, the installer starts.
If auto-start is not enabled on your computer, double-click the drive icon for your CD-ROM, and then double-click CTE 1400 Design Studio.exe.
Step 3 Follow the instructions in the installer.
By default, Design Studio is installed in C:\Program Files\Cisco\CTE 1400\ Design Studio\2.0.
Step 4 Follow the instructions in Chapter 2 of the Design Studio User Guide to install and configure the wireless device simulators used to preview and test your work in Design Studio.
To start Design Studio, you need the following login information from the administrator who set up the CTE 1400:
To start Design Studio, perform these steps:
Step 2 Enter your username and password.
Step 3 Enter the IP address of the CTE 1400.
Step 4 If necessary, change the upload port number.
The default upload port number is 9001. You might need to change the port number if your firewall redirects ports. Contact your CTE administrator if you do not know which port to use.
Step 5 Click OK.
If you cannot connect to a CTE 1400, verify that your computer has a network connection to a running CTE 1400. Contact your CTE administrator for help.
Posted: Mon Aug 18 17:13:03 PDT 2003
All contents are Copyright © 1992--2003 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.