cc/td/doc/product/software/ios124/124tcr
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table Of Contents

Introduction


Introduction


This document describes the commands used to configure ATM features with Cisco IOS software. ATM commands are used to configure ATM interfaces and to configure serial interfaces for ATM access. For ATM configuration information and examples, refer to the "Configuring ATM" section of the Cisco IOS Wide-Area Networking Configuration Guide.

Prior to Cisco IOS Release 12.3(14)T, the commands for configuring ATM features were presented in separate command reference books:

The commands for configuring LAN ATM features were presented in the Cisco IOS Switching Services Command Reference.

The commands for configuring WAN ATM features were presented in the Cisco IOS Wide-Area Networking Command Reference.

For information about configuration, refer to the Cisco IOS Asynchronous Transfer Mode Configuration Guide, Release 12.4.


hometocprevnextglossaryfeedbacksearchhelp

Posted: Sun Feb 26 17:26:19 PST 2006
All contents are Copyright © 1992--2006 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.