cc/td/doc/product/rtrmgmt/cwfw
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table of Contents

Troubleshooting Your Network

Troubleshooting Your Network

This chapter provides the following sections on how to troubleshoot any problems you may encounter when managing the network:

Read your Cisco IOS Release Notes or check CCO for the latest bug information on your devices.

Identifying Device Problems (Dashboard Monitor)

Perform any of the following tasks in CiscoView to isolate the cause of a problem:

Interpreting SNMP Error Messages

CiscoView displays the following SNMP error messages (Table 6-1) resulting from failed command requests in the Status Bar message area:


Table 6-1: SNMP Error Messages
Message Explanation

timeout

Indicates that you can no longer reach the device in the time specified in the CiscoView Properties window.

tooBig

Indicates that the request you made cannot fit into a single packet. Generally, CiscoView splits requests for physical view status until the device can respond. In certain cases, CiscoView assumes that if an agent times out on 20 or more variables, the agent might not be able to respond because the request is too big; it splits the request and resends it. Check that the MTU size on the SNMP interface is as large as possible so that CiscoView does not waste bandwidth by sending more than one request.

genErr

Acts as a collective message name for problems that do not have a unique error message.

noSuchName

Indicates that a request for a variable was sent to a variable that is not accessible. This occurs if you are not using the correct Community string.

badValue

Indicates that the agent did not respond within the time interval specified by the timeout/retries field in the CiscoView Properties window. This can also indicate the use of an incorrect community string.


hometocprevnextglossaryfeedbacksearchhelp
Posted: Wed Sep 25 21:20:05 PDT 2002
All contents are Copyright © 1992--2002 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.