|
|
Information on starting an EM session is presented in the following sections:
To check the status of Cisco EMF/EM, enter commands as follows:
(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)
A message appears indicating that the Cisco EMF manager system is running. A list of running processes is also displayed. If Cisco EMF is not active, a message appears indicating that the Cisco EMF manager system is not running.
When you run a Cisco EMF query, verify that the cisco10kMCon process is running. If the cisco10kMCon process is not running, the EM may be installed incorrectly and may need to be reinstalled.
Starting the Cisco EMF manager system automatically starts the EM.
To start the Cisco EMF manager system, follow these steps.
Step 2 Log in as a root user.
Step 3 Start the Cisco EMF manager system by entering the following:
(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)
The Cisco EMF and EM processes start.
Any type of user (not only root users) can start a Cisco EMF user session.
Step 4 To start a Cisco EMF/EM user session, enter commands as follows:
(Replace CEMF_ROOT with the name of the directory where Cisco EMF is installed.)
Step 5 Enter a username and a password. (The default username is admin, and the default password is admin.)
To stop only the Cisco EMF/EM user session, do the following:
When you close the Launchpad window, your user session is terminated.
Step 2 Confirm your decision to quit the Cisco EMF manager system by clicking OK.
The Cisco EMF/EM user session ends.
Posted: Tue May 20 10:08:44 PDT 2003
All contents are Copyright © 1992--2003 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.
