|
Table Of Contents
Release Notes for Cisco ONS 15305 Release 1.0
Resolved Caveats for Release 1.0
New Features and Functionality
Obtaining Technical Assistance
Release Notes for Cisco ONS 15305 Release 1.0
June, 2003
Release notes address closed (maintenance) issues, caveats, and new features for the Cisco ONS 15305. For detailed information regarding features, capabilities, hardware, and software introduced with this release, refer to Release 1.0 of the Cisco ONS 15305 Installation and Operations Guide. For the most current version of the Release Notes for Cisco ONS 15305 Release 1.0, visit the following URL:
http://www.cisco.com/en/US/products/hw/optical/ps2001/prod_release_notes_list.html
Cisco also provides Bug Toolkit, a web resource for tracking defects. To access Bug Toolkit, visit the following URL:
http://www.cisco.com/cgi-bin/Support/Bugtool/launch_bugtool.pl
Contents
Resolved Caveats for Release 1.0
New Features and Functionality
Obtaining Technical Assistance
Changes to the Release Notes
This section documents supplemental changes that have been added to the Release Notes for Cisco ONS 15305 Release 1.0 since the production of the Cisco ONS 15305 System Software CD for Release 1.0.
The following changes have been added to the release notes for Release 1.0.
Caveats Added
The following caveats have been added.
Caveats
Review the notes listed below before deploying the ONS 15305. Caveats with DDTS tracking numbers are known system limitations that are scheduled to be addressed in a subsequent release. Caveats without DDTS tracking numbers are provided to point out procedural or situational considerations when deploying the product.
DDTS # CSCeb22543
On 8xSTM1 cards there may be packet losses for LAN traffic mapped on STM1, and "DXC inlet bit error alarm" conditionsmay be raised, when 8xSTM1 cards are exposed to extreme temperature cycles (-5 to 50°C with 2 hours dwell at each extreme temperature, and 1°C/min gradients). The packet losses and raised condition can occur on the 8STM1 card. This only occurs under temperature stress. The frequence with which the issue has been observed is an average of 10 packets lost, and less than 100 alarms recorded in a 12 hours cycle. No failures have been detected in nominal conditions.
DDTS # CSCea71600
When power cycling (power on/off at different termperatures) the 8xSTM1 card, the card may fail to recover operation after the power on/off, and may remain in an alarmed state without carrying traffic. In this case the card indicates "DXC inlet failure alarm." The card's LED will also be red. The card recovers normal operation after a software reset. This issue occurs approximately one out of every 20 power on/offs.
DDTS # CSCea34055
When a module with one or more Ethernet switches is hot-inserted in a free slot of the ONS 15305, some packet loss may occur for any IP traffic currently being forwarded by other modules already present in the ONS 15305. This issue will be resolved in a future release.
DDTS # CSCea34421
Multicast BPDU packets are mistakenly forwarded when spanning tree is disabled. This issue will be resolved in a future release.
DDTS # CSCeb19897
When multiple VC12 containers used by the same Ethernet circuit take different paths in an SDH network, the 6.5 ms tolerance to delay between the separately routed packets does not work properly and 25-30% of the traffic may be lost. This issue will be resolved in a future release.
DDTS # CSCea31245
If you send 100 MB from two ports to a single port (for example, to test flow control), 64 byte packets are lost. If you increase the size to 75 bytes, packets are no longer lost. This type of traffic is not, however, typical for a device in normal operation. This issue will be resolved in a future release.
DDTS # CSCea33042
Same priority and same packet size may yield different traffic flows. When four streams are set up and each has the same packet size (64 byte) going across a 100 MB STM-1 path to another ONS 15305, each of the streams can be off as much as 50%. This is not always the case, however. Sometimes the traffic can be equally distributed. Using random packet sizes, the distribution tends to be more equal. This type of traffic in not typical for a device in normal operation; however, the issue can occur in a lab test. This issue will be resolved in a future release.
DDTS # CSCea33354
If a mirrored port becomes congested and flow control is enabled, no pause packets are generated toward ports belonging to other modules. Flow control fails when ports used for mirroring become congested. If traffic to a mirrored port is sent from a LAN port situated in a different module from that of the mirrored port, pause packets are not received and mirrored packets are lost. Actual traffic flow is not disturbed by the mirrored port flow control problem, and the copy port traffic is handled correctly. This issue will be resolved in a future release.
Resolved Caveats for Release 1.0
Because Release 1.0 is a first release, there are no resolved caveats.
New Features and Functionality
This section highlights new features and functionality for Release 1.0. Because Release 1.0 is a first release, there are no new features or functionality. For an overview of features of the 15305, consult the Cisco ONS 15305 Installation and Operations Guide, Release 1.0.
Related Documentation
Release-Specific Documents
None.
Platform-Specific Documents
•Cisco ONS 15305 Quick Installation Guide, Release 1.0
•Cisco ONS 15305 Installation and Operations Guide, Release 1.0
•Cisco Edge Craft, Software Guide
Obtaining Documentation
The following sections provide sources for obtaining documentation from Cisco Systems.
World Wide Web
You can access the most current Cisco documentation on the World Wide Web at the following sites:
Documentation CD-ROM
Cisco documentation and additional literature are available in a CD-ROM package, which ships with your product. The Documentation CD-ROM is updated monthly and may be more current than printed documentation. The CD-ROM package is available as a single unit or as an annual subscription.
Ordering Documentation
Cisco documentation is available in the following ways:
•Registered Cisco Direct Customers can order Cisco Product documentation from the Networking Products MarketPlace:
http://www.cisco.com/cgi-bin/order/order_root.pl
•Registered Cisco.com users can order the Documentation CD-ROM through the online Subscription Store:
http://www.cisco.com/go/subscription
•Nonregistered Cisco.com users can order documentation through a local account representative by calling Cisco corporate headquarters (California, USA) at 408 526-7208 or, in North America, by calling 800 553-NETS(6387).
Documentation Feedback
If you are reading Cisco product documentation on the World Wide Web, you can submit technical comments electronically. Click Feedback in the toolbar and select Documentation. After you complete the form, click Submit to send it to Cisco.
You can e-mail your comments to bug-doc@cisco.com.
To submit your comments by mail, use the response card behind the front cover of your document, or write to the following address:
Attn Document Resource Connection
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-9883We appreciate your comments.
Obtaining Technical Assistance
Cisco provides Cisco.com as a starting point for all technical assistance. Customers and partners can obtain documentation, troubleshooting tips, and sample configurations from online tools. For Cisco.com registered users, additional troubleshooting tools are available from the TAC website.
Cisco.com
Cisco.com is the foundation of a suite of interactive, networked services that provides immediate, open access to Cisco information and resources at anytime, from anywhere in the world. This highly integrated Internet application is a powerful, easy-to-use tool for doing business with Cisco.
Cisco.com provides a broad range of features and services to help customers and partners streamline business processes and improve productivity. Through Cisco.com, you can find information about Cisco and our networking solutions, services, and programs. In addition, you can resolve technical issues with online technical support, download and test software packages, and order Cisco learning materials and merchandise. Valuable online skill assessment, training, and certification programs are also available.
Customers and partners can self-register on Cisco.com to obtain additional personalized information and services. Registered users can order products, check on the status of an order, access technical support, and view benefits specific to their relationships with Cisco.
To access Cisco.com, go to the following website:
Technical Assistance Center
The Cisco TAC website is available to all customers who need technical assistance with a Cisco product or technology that is under warranty or covered by a maintenance contract.
Contacting TAC by Using the Cisco TAC Website
If you have a priority level 3 (P3) or priority level 4 (P4) problem, contact TAC by going to the TAC website:
P3 and P4 level problems are defined as follows:
•P3—Your network performance is degraded. Network functionality is noticeably impaired, but most business operations continue.
•P4—You need information or assistance on Cisco product capabilities, product installation, or basic product configuration.
In each of the above cases, use the Cisco TAC website to quickly find answers to your questions.
To register for Cisco.com, go to the following website:
http://www.cisco.com/register/
If you cannot resolve your technical issue by using the TAC online resources, Cisco.com registered users can open a case online by using the TAC Case Open tool at the following website:
http://www.cisco.com/tac/caseopen
Contacting TAC by Telephone
If you have a priority level 1 (P1) or priority level 2 (P2) problem, contact TAC by telephone and immediately open a case. To obtain a directory of toll-free numbers for your country, go to the following website:
http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml
P1 and P2 level problems are defined as follows:
•P1—Your production network is down, causing a critical impact to business operations if service is not restored quickly. No workaround is available.
•P2—Your production network is severely degraded, affecting significant aspects of your business operations. No workaround is available.
This document is to be used in conjunction with the documents listed in the "Related Documentation" section.
CCIP, CCSP, the Cisco Arrow logo, the Cisco Powered Network mark, Cisco Unity, Follow Me Browsing, FormShare, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Aironet, ASIST, BPX, Catalyst, CCDA, CCDP, CCIE, CCNA, CCNP, Cisco, the Cisco Certified Internetwork Expert logo, Cisco IOS, the Cisco IOS logo, Cisco Press, Cisco Systems, Cisco Systems Capital, the Cisco Systems logo, Empowering the Internet Generation, Enterprise/Solver, EtherChannel, EtherSwitch, Fast Step, GigaStack, Internet Quotient, IOS, IP/TV, iQ Expertise, the iQ logo, iQ Net Readiness Scorecard, LightStream, MGX, MICA, the Networkers logo, Networking Academy, Network Registrar, Packet, PIX, Post-Routing, Pre-Routing, RateMUX, Registrar, ScriptShare, SlideCast, SMARTnet, StrataView Plus, Stratm, SwitchProbe, TeleRouter, The Fastest Way to Increase Your Internet Quotient, TransPath, and VCO are registered trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries.
All other trademarks mentioned in this document or Web site are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (0304R)
Copyright © 2003, Cisco Systems, Inc.
All rights reserved.
Posted: Fri Sep 14 09:09:56 PDT 2007
All contents are Copyright © 1992--2007 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.