|
|
To enable ATM cell payload scrambling on a DMT subscriber port, use the payload-scrambling profile configuration command. To disable payload scrambling, use the no form of the command.
payload-scramblingThis command has no keywords or arguments.
Enabled
Profile configuration
| Release | Modification |
|---|---|
12.1(1)DA | This command was introduced. |
The two ends of a connection must have the same payload scrambling value—that is, payload scrambling must be enabled at both ends or disabled at both ends. The line does not train if payload scrambling is enabled at one end and disabled at the other end.
Enabling or disabling payload scrambling does not untrain or retrain a port.
This command disables payload scrambling for the default DSL profile:
DSLAM# configure terminal
DSLAM(config)# dsl-profile default
DSLAM(cfg-dsl-prof)# no payload-scrambling
Posted: Wed Jul 24 11:53:32 PDT 2002
All contents are Copyright © 1992--2002 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.