Appendix A: Technical Specifications

This appendix provides the technical specifications for the Cisco 6100 with NI-2 system. The appendix contains the following sections:

Hardware Specifications

Cisco 6100 with NI-2 System

Table A-1 Hardware Specifications

Specification		Description
Dimensions	Cisco 6100 Cisco 6120 Fan tray	9 RUs¹—23 in. x 15.75 in. x 12 in. (58.42 cm x 40.005 cm x 30.48 cm) 4 RUs—23 in. x 7 in. x 12 in. (58.42 cm x 17.78 cm x 30.48 cm) 2 RUs—23 in. x 3.5 in. x 12 in. (58.42 cm x 8.89 cm x 30.48 cm)
Weight	Cisco 6100 Cisco 6120 Fan tray	Empty—approximately 31 lb (14.06 kg) Loaded—approximately 62 lb (28.12 kg) Empty—approximately 16 lb (7.26 kg) Loaded—approximately 34 lb (15.42 kg) Loaded—approximately 18.45 lb (8.37 kg)
Network interface		ATM OC-3c (single- or multimode fiber), ATM DS3
ADSL interface		CAP—Up to 7.168 Mbps downstream/1.088 Mbps upstream DMT-2—Up to 8.032 Mbps downstream/864 kbps upstream G.lite—Up to 1.536 Mbps downstream/512 kbps upstream
Craft interface		Console terminal connection on the NI-2 card
Management access		RJ-45 interface for craft alarm discovery RJ-45 Ethernet ATM in-band management
External alarm contacts		Single dry contact alarm input (NO)
Power requirements		-48 VDC Note See "Preparing for Installation" for detailed power requirements.
CO operating requirements	Temperature Altitude Humidity	41 to 104ºF (5 to 40ºC)—Operating 23 to 163ºF (-5 to 50ºC)—Short term operating -60 meters to 3200 meters 5 to 90% (noncondensing)
Subtending		NI-2 card

1RU = rack unit. An RU is equal to 1.75 inches (4.45 cm).

Quad-Port Flexi ATU-C Line Card

Table A-2 Quad-Port Flexi ATU-C Line Card Specifications

Specification	DMT-2 Mode	CAP Mode	G.lite Mode
Standards supported	ITU G.dmt (G.992.1) ANSI T1.413 Issue 2	RADSL¹	ITU G.lite (G.992.2)
Power consumption	17.5W	13.5W	13.5W
Maximum data rates (per port) Downstream Upstream	8.032 Mbps 864 kbps	7.168 Mbps 1.088 Mbps	1.536 Mbps 512 kbps
External interfaces	4 (no connectors on card)
Internal hardware	AMD 186-based 3.3V 18-MHz CPU 128-KB SRAM 512K flash
Dimensions	Height: 6.07 in. (15.42 cm) Depth: 8.50 in. (21.59 cm) Width: 0.88 in. (2.24 cm)
Weight	0.875 lb (0.4 kg)

1Rate-adaptive digital subscriber line.

DS3/2DS3 NI-2 Card

Table A-3 DS3/2DS3 NI-2 Card Specifications

Specification	Description
Internal hardware	150 MHz RC64475 CPU Galileo GT64120 system controller 1M x 32 bootflash 4M x 32 Flash 512 KB boot EPROM
Dimensions	Height: 12.38 in. (31.45 cm) Depth: 8.50 in. (21.59 cm) Width: 1.80 in. (4.57 cm)
Weight	3.0 lb (1.36 kg)
Level 2 protocol	ATM
External interfaces	Three DS3 (44.736 Mbps) coaxial ports
Connector type	BNC¹
Impedance	75 ohms (nominal)
Line encoding	B3ZS
Framing	C-bit parity, optionally PLCP with M23, otherwise Add Drop Multiplexer (ADM)
Power consumption	33.5W

1The Bayonet-Neill-Concelman (BNC) connectors are located on the system I/O card which is installed on the backplane of the chassis.

OC-3c/OC-3c NI-2 Card Specifications

Table A-4 lists the specifications of the single-mode and multimode versions of the OC-3c/OC-3c NI-2 card.

Table A-4 OC-3c/OC-3c NI-2 Card Specifications

Specification	Description
Internal hardware	150 MHz RC64475 CPU Galileo GT64120 system controller 1M x 32 boot flash¹ (4 MB) 4M x 32 Flash (16 MB) 512 KB boot EPROM
Dimensions	Height: 12.38 in. (31.45 cm) Depth: 8.50 in. (21.59 cm) Width: 1.80 in. (4.57 cm)
Weight	3.0 lb (1.36 kg)
Layer 2 protocol	ATM
Power consumption	33.5W
Minimum software and network management requirement	Cisco IOS Non-redundant NI-2 card configurations—Release 12.1(1)DA Redundant NI-2 card configurations—Release 12.1(7)DA CDM—Release 3.0/3.2 (optional)
	Single-Mode Card	Multimode Card
External interfaces	Two OC-3c/STM-1 (155 Mbps) single-mode ports	Two OC-3c/STM-1 (155 Mbps) multimode ports
Connector type	SC-PC	SC-PC
Fiber type	Intermediate reach single mode	Multimode
Average transmitted power	-15 to -8 dBm	-20 to -14 dBm
Average received power	-8 dBm	-11 dBm
Transmission distance	Up to 12 miles (19.3 km)	Up to 1.2 miles (1.93 km)
Wavelength	1310 nm	1300 nm

1The version of the OC-3c/OC-3c NI-2 card with enhanced upstream bandwidth features (NI2-155SM-155SM2 and NI2-155MM-155MM2) has a 2M x 32 bootflash (8 MB).

Software Specifications

Table A-5 Software Specifications

Specification	Description
Management protocols	IOS software support for SNMP to CEMF¹
Management applications	IOS² Release 12.1(2)DA CDM³ Release 3.2
Management interfaces	In band—ATM VC Out of band—10BaseT Ethernet, console, auxiliary

Specification

Description

Management protocols

IOS software support for SNMP to CEMF¹

Management applications

IOS² Release 12.1(2)DA
CDM³ Release 3.2

Management interfaces

In band—ATM VC

Out of band—10BaseT Ethernet, console, auxiliary

1CEMF = Cisco Element Management Framework

2IOS = Internet Operating System

3CDM = Cisco DSL Manager