Installing the RADIUS Listener LEG

Table Of Contents

Installing the RADIUS Listener LEG

Installing the RADIUS Listener LEG Software

Uninstalling the RADIUS Listener LEG

Installing the RADIUS Listener LEG

This module describes the procedures for installing the software on the Subscriber Manager. It also describes uninstalling the software.

The RADIUS Listener LEG is part of the SM installation package. The installation package also includes configuration files and the Command-Line Utility of the LEG.

• Installing the RADIUS Listener LEG Software

• Uninstalling the RADIUS Listener LEG

Installing the RADIUS Listener LEG Software

Step 1 Edit the RADUIS Listener LEG configuration file.

To run the RADIUS Listener LEG at SM startup, set the start parameter to yes. See Information About Configuring the General Settings, page 3-1.

Step 2 Load the configuration file using the p3sm command-line utility.

Run the p3sm command-line utility from the SM CLU sm-inst-dir/sm/server/bin ( sm-inst-dir refers to the SM installation directory):

>p3sm --load-config
Step 3 Configure the NAS devices that are sending RADIUS Accounting messages to the RADIUS Listener LEG.

The NAS devices may be RADIUS servers acting as RADIUS clients that proxy or forward RADIUS accounting messages to the RADIUS Listener.

These RADIUS clients must be configured according to the RADIUS Listener configuration, as performed in Step 1 above. There are many different RADIUS client devices, each of which is configured in a different manner. See Configuring the NAS Devices, page 3-6 for instructions on configuring the RADIUS clients on NAS devices.

Uninstalling the RADIUS Listener LEG

Step 1 Edit the SM configuration file and set the RADIUS Listener start parameter to no.

For further information, see Information About Configuring the General Settings, page 3-1.

Note Setting the start parameter to nodoes not remove the RADIUS Listener LEG from the SM installation. You can reinstall the software again by setting the start parameter to yes.

Step 2 Run the p3sm CLU.

>p3sm --load-config