|
|
This document contains a summary of the new and changed features for the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers for Cisco IOS release 12.0(10)W5(18c).
Table 1 lists the new and changed features in the ATM Switch Router Port Adapter and Interface Module Installation Guide:
Table 1 New and Changed Features in the ATM Switch Router Port Adapter and Interface Module Installation Guide
| Feature | Description | Chapter or Section |
|---|---|---|
The ATM router module is available on the Catalyst 8540 MSR, and LightStream 1010 ATM switch routers. |
Chapter 15, "ATM Router Modules" |
Table 2 lists the new and changed features in the Guide to ATM Technology :
Table 2 New and Changed Features in the Guide to ATM Technology
| Feature | Description | Chapter |
|---|---|---|
Chapter 5, "Layer 3 Protocols over ATM" |
||
Chapter 5, "Layer 3 Protocols over ATM" |
Table 3 lists the new and changed features in the ATM Switch Router Software Configuration Guide :
Table 3 New and Changed Features in the ATM Switch Router Software Configuration Guide
| Feature | Description | Chapter or Section |
|---|---|---|
This feature is available on the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. |
Chapter 20, "Configuring IMA Port Adapter Interfaces." |
|
The ATM router module is available on the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. |
Chapter 21, "Configuring ATM Router Module Interfaces." |
|
This feature allows the transmission of multiple Layer 3 and bridged frames over ATM. |
Chapter 21, "Configuring ATM Router Module Interfaces," in the "Configuring RFC 1483" section on page 21-7. |
|
This feature is available on both the route processor and the ATM router module. |
Chapter 21, "Configuring ATM Router Module Interfaces," in the "Configuring Classical IP over ATM in a PVC Environment" section on page 21-10. |
Table 4 lists the new and changed features in the ATM Switch Router Command Reference:
Table 4 New and Changed Features in the ATM Switch Router Command Reference
| Feature | Description | Chapter or Section |
|---|---|---|
This feature is available on the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. |
Chapter 9, "I Commands." |
|
The epc port-reload command indicates whether a stuck port should be shutdown, or reset and reloaded. The epc portstuck-wait command specifies the amount of time before signalling a port stuck failure. |
Chapter 6, "E Commands." |
Posted: Tue Apr 8 13:06:59 PDT 2003
All contents are Copyright © 1992--2002 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.