|
This chapter lists SNMP traps. These traps display as type "GENERIC." For more detailed information about SNMP traps, refer to IETF RFC 1157, A Simple Network Management Protocol, by J. Case et. al.
If you need help interpreting these traps, contact your customer support representative.
Trap Name | Authentication Failure |
Trap Text | Authentication Failure Trap from <node name>, System Up Time <XX Hr XX Min XX Sec> |
Description | This trap indicates that the source of an SNMP request received by the specified switch has been sent a protocol message that is not properly authenticated. |
Action | You may wish to verify that the sources of SNMP requests received by the switch are using an SNMP community name string that matches one of those configured on the switch, and that the IP address of the source is among those configured as acceptable on the switch. (See the LightStream 2020 Configuration Guide for information on configuring IP addresses for authentication.) |
Trap Name | Cold Start |
Trap Text | Cold Start Trap from <node name>, System Up Time <XX Hr XX Min XX Sec> |
Description | This trap indicates that the specified node's power has just come on. |
Action | No action is required. |
Trap Name | Link Up |
Trap Text | Link up trap from <node name>, System Up Time <XX Hr XX Min XX Sec> Port <port#> |
Description | This trap indicates that a node has returned to service. |
Action | No action is required. |
|