The commands shown in this chapter apply to the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. Where an entire command or certain attributes of a command have values specific to a particular switch or switch router, an exception is indicated by the following callouts:
Catalyst 8540 MSR
Catalyst 8510 MSR and LightStream 1010
Note Commands that are identical to those documented in the Cisco IOS software
documentation have been removed from this chapter.
Note Commands that no longer function as expected in ATM environments have also been
removed from this chapter.
Refer to Appendix D of this command reference for a detailed list of commands that have been removed, changed or replaced.
verify
To verify the checksum of a file on a Flash device, use the verify EXEC command. This command replaces the copy verify and copy verify flash commands.
verify [device:]filename
Syntax Description
device:
Device containing the file whose checksum is being verified. The colon (:) is required. Valid devices are as follows:
bootflash: This device is the internal Flash memory.
sec-bootflash: The secondary internal Flash memory on the redundant route processor.
slot0: The first PC slot on the route processor card and is the initial default device.
sec-slot0: The first PC slot on the redundant route processor card. (Catalyst 8540 MSR)
slot1: The second PC slot on the route processor card.
sec-slot1: The second PC slot on the redundant route processor card. (Catalyst 8540 MSR)
When you omit this argument, the system verifies the checksum of the specified file on the current working device.
filename
Name of a file on the specified Flash device. The file can be of any type. The maximum filename length is 63 characters.
Defaults
The current working device is the default device.
Command Modes
EXEC
Command History
Release
Modification
11.1(4)
New command
Usage Guidelines
Use the verify command to verify the checksum of a file before using it. When you omit the device: argument, the system verifies the checksum of the specified file on the current working device.
Examples
The following example shows how to get information and verify the test-image file using the dir and verify commands.