|
The commands shown in this chapter apply to the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. Where an entire command or certain attributes of a command have values specific to a particular switch or switch router, an exception is indicated by the following callouts:
Refer to Appendix D of this command reference for a detailed list of commands that have been removed, changed or replaced.
To filter ATM signalling call failure based on the outgoing interface rejected call, use the outgoing-port ATM signalling diagnostics configuration command. To return the outgoing port to the default, use the no form of this command.
Syntax Description
|
Defaults
Command Modes
ATM signalling diagnostics configuration
Command History
Usage Guidelines
The default 0 means the incoming interface is not considered during filtering.
Examples
The following example shows the outgoing-port command.
Posted: Tue Aug 12 17:28:38 PDT 2003
All contents are Copyright © 1992--2003 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.