RFC index | STD index | BCP index | FYI index
Plain text | gzipped plain text | A4 postscript | A4 postscript, 2 up | A4 postscript, 4 up
Network Working Group R. Hinden Request for Comments: 1897 Ipsilon Networks Category: Experimental J. Postel ISI January 1996 IPv6 Testing Address Allocation Status of this Memo This document specifies an Experimental protocol for the Internet community. This memo does not specify an Internet standard of any kind. Discussion and suggestions for improvement are requested. Distribution of this memo is unlimited.

1.0 Introduction

This document describes an allocation plan for IPv6 addresses to be used in testing IPv6 prototype software. These addresses are temporary and will be reclaimed in the future. Any IPv6 system using these addresses will have to renumber at some time in the future. These addresses will not to be routable in the Internet other than for IPv6 testing. The addresses described in this document are consistent with the IPv6 Addressing Architecture [ARCH]. They may be assigned to nodes manually, with IPv6 Auto Address Allocation [AUTO], or with DHCP for IPv6 [DHCPv6]. Hinden & Postel Experimental [Page 1]
RFC 1897 IPv6 Testing Address Allocation January 1996

2.0 Address Format

The address format for the IPv6 test address is consistent with the provider-based unicast address allocation [PRVD] which is as follows: | 3 | 5 bits | 16 bits | 8 | 24 bits | 8 | 64 bits | +---+----------+----------+---+------------+---+----------------+ |010|RegistryID|ProviderID|RES|SubscriberID|RES|Intra-Subscriber| +---+----------+----------+---+------------+---+----------------+ The specific allocation of each field of the test address format is as follows: | 3 | 5 bits | 16 bits | 8 | 24 bits | 8 | 16 bits|48 bits| +---+----------+----------+---+------------+---+--------+-------+ | | |Autonomous| | IPv4 | | Subnet | Intf. | |010| 11111 | System |RES| Network |RES| | | | | | Number | | Address | | Address| ID | +---+----------+----------+---+------------+---+--------+-------+ where: 010 This is the Format Prefix used to identify provider-based unicast addresses. 11111 This is a Registry ID reserved by the IANA. The initial use of addresses in this Registry ID for IPv6 testing is temporary. All users of these addresses will be required to renumber at some time in the future. Autonomous System Number This is the current autonomous system number assigned to the provider providing internet service to the an IPv6 testers organization. For example for IPv6 testers receiving internet service from BBN Barrnet would use autonomous system number 189. This would be coded in the autonomous system field of the address as follows: 0000 0000 1011 1101 (binary) Hinden & Postel Experimental [Page 2]
RFC 1897 IPv6 Testing Address Allocation January 1996 The values for the autonomous system number of an organization's provider can be obtained from that provider, or can be looked up in the "whois" database maintained by the internic.net. RES This field is reserved and must be set to zero. IPv4 Network Address This is based on the current IPv4 routable address for the subscriber which the interface is connected. It is formed by taking the high order 24 bits of the IPv4 address. For example for an IPv4 address (in IPv4 syntax): IPv4 Address ------------ the value to put in this field of IPv6 address is: IPv4 Format Hex ------------ ------ 39.11.22 270B16 This technique for generating values for this field only works for subscribers which have IPv4 subscriber prefixes less than equal to 24 bits long. There may be subscribers using IPv4 addresses with longer subscriber prefixes, but this conflict is expected to be very rare. Subscribers with subscriber prefixes larger than 24 bits should use the remaining bits in the IPv4 prefix as the high order bits in the Subnet Address field. RES This field is reserved and must be set to zero. Subnet Address The Subnet ID identifies a specific physical link on which the interface is located. There can be multiple subnets on the same physical link. A specific subnet can not span multiple physical links. The assignment of values for this field is left to an individual subscriber. One possible algorithm to generate values for this field is to use the bits in the IPv4 address which identify the IPv4 subnet. Hinden & Postel Experimental [Page 3]
RFC 1897 IPv6 Testing Address Allocation January 1996 Interface ID This is the unique identifier of the interface on the link, usually the 48-bit IEEE 802 MAC address of the interface if available.

4.0 References

[ARCH] Hinden, R., and S. Deering, Editors, "IP Version 6 Addressing Architecture", RFC 1884, Ipsilon Networks, Xerox PARC, December 1995. [AUTO] Thomson, S., "IPv6 Stateless Address Autoconfiguration", Work in Progress. [DHCP6] Bound, J., "Host Configuration Protocol for IPv6", Work in Progress. [PROV] Rekhter, Y., and P. Lothberg, "An IPv6 Provider-Based Unicast Address Format", Work in Progress.

5.0 Security Considerations

Security issues are not discussed in this memo.

6.0 Authors' Addresses

Robert M. Hinden Ipsilon Networks, Inc. 2191 E. Bayshore Road, Suite 100 Palo Alto, CA 94303 USA Phone: +1 415 846 4604 Fax: +1 415 855 1414 EMail: hinden@ipsilon.com Jon Postel Information Sciences Institute 4676 Admiralty Way Marina del Rey, CA 90292-6695 USA Phone: +1 310 822 1511 Fax: +1 310 823 6714 EMail: postel@isi.edu Hinden & Postel Experimental [Page 4]