Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
 Contact HP
More options
HP.com home
HP Integrity Virtual Machines Version 4.0 Release Notes

Chapter 1 Introduction


Technical documentation

Complete book in PDF
Content starts here

  Table of Contents


Thank you for installing HP Integrity Virtual Machines (also called Integrity VM). This Release Notes document describes the changes in this version of the Integrity VM product.

The Integrity VM Version 4.0 release introduces support for the HP-UX 11i v3 operating system on the VM Host, as well as support for agile device names, automatic cell balancing, per-guest capping, and more.

HP Integrity Virtual Machines Version 4.0 is supported as a host on HP Integrity servers or nPartitions running HP-UX 11i v3 September 2008 0809 or later. For complete information about the requirements for installing Integrity VM, see the HP Integrity Virtual Machines Version 4.0 Installation, Configuration, and Administration manual.

NOTE: Integrity VM patches for fixes developed subsequent to the Integrity VM V4.0 release are available at the HP IT Resource Center (ITRC) website: http://www.itrc.hp.com. Go to this website and install the following patches:
  • PHSS_38566 — HPVM-CORE patch

  • PHSS_38567 — VM Scheduler (vmagent) patch

  • PHSS_38610 — 11.23 HPVMUPGRADE patch

  • PHSS_38611 — 11.31 HPVMUPGRADE patch

  • PHSS_38631 — HPVM Serviceguard Tool kit patch

HP strongly recommends that you always install the latest AVIO components for both the VM Host and guest. Always check the software depot website,http://software.hp.com, for the latest version of AVIO software. Search for the keyword HPVM AVIO.

For the most up-to-date information about HP Integrity Virtual Machines, see the documentation on the HP Technical Documentation website, http://www.docs.hp.com.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
2008 Hewlett-Packard Development Company, L.P.