CPU: Adding or Deleting by Hardware Path

The syntax for specifying by hardware path is:

-[a|d] cpu:hw_path

where:

-a: add
-d: delete
hw_path: the hw_path (you can find the hardware path using ioscan or vparstatus -v)




	NOTE: The target virtual partition can be up or down when specifying by hardware path. CPUs that are added using the hardware path syntax can be deleted only by using the hardware path syntax. Adding or deleting CPUs by hardware path changes total only when the virtual partition is up (unless the operation is an addition and the specified CPU is already assigned to the partition). If the virtual partition is down, total is not changed and becomes a high boundary. For example, if keira2 is down and total is set to 2, you cannot have more than 2 CPUs added by hardware path. This is for A.03.xx backwards compatibility.

Example

To add the CPUs at 0/10 and 0/11 to keira2:
keira1# vparmodify -p keira2 -a cpu:0/10 -a cpu:0/11

Using both the Hardware Path Specification and CLP specification

Although you can add and delete CPUs by hardware path, to avoid confusion it is recommended that you specify by cell rather than by hardware path. The exception is for dual-core processors.

For dual-core processors, if you wish to have both cores of a processor assigned to the same virtual partition, you should specify by hardware path instead of by cell. Specifying by cell cannot guarantee that both cores in the processor are the CPUs chosen by the vPars Monitor and assigned to the target virtual partition, although the vPars Monitor will attempt to do this whenever possible.

For more information on configuring dual-core processors, see “CPU: Dual-Core Processors”.

CPU: Adding or Deleting by Hardware Path

Technical documentation

» Table of Contents

» Glossary

» Index

Example

Using both the Hardware Path Specification and CLP specification