Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
Ignite-UX Quick Start Guide: Create an Ignite-UX Server and Cold-Install Clients

Chapter 2 Cold-installing a Client Across the Network


Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

This chapter describes adding a client to an Ignite-UX server, and then installing HP-UX on that client from the Ignite-UX server over the network. You must have superuser privileges to cold-install a client. You can stop anywhere in this procedure and resume where you left off at later time.

This document assumes the network boot clients are on the same subnet as the Ignite-UX server.

Glossary terms are italicized when used for the first time in this manual.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2007, 2008 Hewlett-Packard Development Company, L.P.