|
|
United States-English | |
|
|
 |
|
HP-UX System Administrator's Guide: Logical Volume Management: HP-UX 11i Version 3 > Chapter 3 Administering LVM
Administering Dump Logical Volumes |
|
|
This section describes LVM information about using logical volumes as dump devices. For information on configuring and managing dump devices, see HP-UX System Administrator's Guide: Overview. To create a dump logical volume, use the lvcreate command. You must set a contiguous allocation policy using the -C y option and disable bad block relocation using the -r n option. For example:
For more information, see lvcreate(1M). After creating a logical volume to be used as a dump device, use the lvlnboot command with the -d option to update the dump information used by LVM. If you created a logical volume /dev/vg00/lvol2 for use as a dump area, update the boot information by entering the following:
To discontinue the use of a currently configured logical volume as a dump device, use the lvrmboot command with the -d option. For example:
You can then use the logical volume for other purposes. To remove the logical volume completely, see “Removing a Logical Volume”. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 Printable version |
|
|
|
|
|
|||||||||||||||
|
|||||||||||||||
