Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
nPartition Administrator's Guide > Chapter 4 Using Management Interfaces and Tools

Command Reference for Service Processor Commands


Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

Table 4-2 lists the commands available from the service processor command menu (the MP:CM> or GSP:CM> prompt).

The following categories of commands are available:

Some commands are restricted to users with Operator or Administrator authority. Also note that the available set of commands may differ depending on the utility revision level and server hardware model.

For details on these commands, use the help (HE: Help) feature at the service processor Main Menu. Enter the command name at the MP:HELP or GSP:HELP prompt for syntax, restrictions, and other information.

Table 4-2 Service Processor (MP or GSP) Command Reference


Service Commands — Service Processor (MP or GSP). Commands for general server complex administration and nPartition management.

BOBoot an nPartition past Boot is Blocked (BIB).
DFDisplay FRU information of an entity.
MAReturn to the Main menu.
MRModem reset.
PCIOLADActivate/deactivate a PCI card.
PEPower entities on or off.
REReset entity.
RRReset an nPartition for reconfiguration; the nPartition remain inactive, in the shutdown for reconfig state.
RSReset an nPartition.
TCSend a TOC signal to an nPartition.
TEBroadcast a message to all users of the MP Command Handler.
VMMargin the voltage in a cabinet.


Display a list of MP connected users.

Status Commands — Service Processor (MP or GSP). Commands for displaying hardware and nPartition information.


Display nPartition cell assignments.


Display the list of available commands.


Display IO chassis/cell connectivity.


Display LAN connected console status.


Display the status of the modem.


Display detailed power and hardware configuration status.


Display revisions of all firmware entities in the complex.

System and Access Configuration Commands — Service Processor (MP or GSP). Commands for managing server complex accounts, security, and nPartition configuration.


Restrict/unrestrict nPartition Reconfiguration Privilege.


Modify default nPartition for this login session.


Rekey Complex Profile locks (unlock Complex Profile).


Display and set (enable/disable) MP remote access methods.


Configure security options and access control (user accounts and passwords).


MP diagnostics and reset.


Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2007 Hewlett-Packard Development Company, L.P.