|
The commands shown in this chapter apply to the Catalyst 8540 MSR, Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. Where an entire command or certain attributes of a command have values specific to a particular switch or switch router, an exception is indicated by the following callouts:
Refer to Appendix D of this command reference for a detailed list of commands that have been removed, changed or replaced.
To reset a specific port adapter, use the hw-module EXEC command.
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
If the subcard is not provided, both subcards in the slot are reset. In the case of a full-width card, the motherboard in the selected slot is reset. The subcard argument indicates a specific subcard in a selected slot. If the subcard is not given, the full-width card in the selected slot is reset.
This command is available to reset port adapters only. The hw-module command cannot be used to reset route processor controllers and switch controllers.
Caution If any active connections are configured on this port, they will be lost until the port adapter restarts. The running configuration is restored only when the port adapter returns to normal operation. |
Examples
The following example resets the port adapter in slot 3.
Related Commands
|
Posted: Tue Aug 12 17:27:21 PDT 2003
All contents are Copyright © 1992--2003 Cisco Systems, Inc. All rights reserved.
Important Notices and Privacy Statement.