Введение
This package is based on the libradius of FreeBSD. This PECL adds full
support for Radius Authentication
(» RFC 2865) and Radius Accounting
(» RFC 2866). This package is available
for Unix (tested on FreeBSD and Linux) and for Windows.
Note:
An exact description for libradius can be found
» here. A detailed description of the
configuration file can be found » here.
Установка
Howto install the package?
- untar the package (usually into php4/ext)
- rename radius-x.x to radius
- run ./buildconf in php4
- run ./configure --enable-radius
- make; make install
or if you would like to have it as .so:
- untar the package
- run phpize in the radius-x.x directory
- run ./configure in the radius-x.x directory
- make; make install
For Windows I recommend to use the
php_radius.dll from
» http://snaps.php.net/.
Вы можете получить не встроенное
расширение PECL с различных страниц снимков
PECL (выберите соответствующий репозиторий для вашей версии
PHP): » PECL для PHP
4.3.x, » PECL для PHP 5.0.x
или » PECL Нестабильные.
Предопределенные константы
Перечисленные ниже константы определены данным расширением и могут быть
доступны только в том случае, если PHP был собран с
поддержкой этого расширения или же в том случае, если
данное расширение подгружается во время выполнения.
-
RADIUS_ACCESS_REQUEST
()
-
Authentication Request
-
RADIUS_ACCESS_ACCEPT
()
-
Access accepted
-
RADIUS_ACCESS_REJECT
()
-
Access rejected
-
RADIUS_ACCOUNTING_REQUEST
()
-
Accounting request
-
RADIUS_ACCOUNTING_RESPONSE
()
-
Accounting response
-
RADIUS_ACCESS_CHALLENGE
()
-
Accsess challenge
-
RADIUS_USER_NAME
(string)
-
Username
-
RADIUS_USER_PASSWORD
(string)
-
Password
-
RADIUS_CHAP_PASSWORD
(string)
-
Chap Password: chappass = md5(ident + plaintextpass + challenge)
-
RADIUS_NAS_IP_ADDRESS
(string)
-
NAS IP-Adress
-
RADIUS_NAS_PORT
(int)
-
NAS Port
-
RADIUS_SERVICE_TYPE
(int)
-
Type of Service, one of:
- RADIUS_LOGIN
- RADIUS_FRAMED
- RADIUS_CALLBACK_LOGIN
- RADIUS_CALLBACK_FRAMED
- RADIUS_OUTBOUND
- RADIUS_ADMINISTRATIVE
- RADIUS_NAS_PROMPT
- RADIUS_AUTHENTICATE_ONLY
- RADIUS_CALLBACK_NAS_PROMPT
-
RADIUS_FRAMED_PROTOCOL
(int)
-
Framed Protocol, one of:
- RADIUS_PPP
- RADIUS_SLIP
- RADIUS_ARAP
- RADIUS_GANDALF
- RADIUS_XYLOGICS
-
RADIUS_FRAMED_IP_ADDRESS
(string)
-
IP-Address
-
RADIUS_FRAMED_IP_NETMASK
(string)
-
Netmask
-
RADIUS_FRAMED_ROUTING
(int)
-
Routing
-
RADIUS_FILTER_ID
(string)
-
Filter ID
-
RADIUS_FRAMED_MTU
(int)
-
MTU
-
RADIUS_FRAMED_COMPRESSION
(int)
-
Compression, one of:
- RADIUS_COMP_NONE
- RADIUS_COMP_VJ
- RADIUS_COMP_IPXHDR
-
RADIUS_LOGIN_IP_HOST
(string)
-
Login IP Host
-
RADIUS_LOGIN_SERVICE
(int)
-
Login Service
-
RADIUS_LOGIN_TCP_PORT
(int)
-
Login TCP Port
-
RADIUS_REPLY_MESSAGE
(string)
-
Reply Message
-
RADIUS_CALLBACK_NUMBER
(string)
-
Callback Number
-
RADIUS_CALLBACK_ID
(string)
-
Callback ID
-
RADIUS_FRAMED_ROUTE
(string)
-
Framed Route
-
RADIUS_FRAMED_IPX_NETWORK
(string)
-
Framed IPX Network
-
RADIUS_STATE
(string)
-
State
-
RADIUS_CLASS
(int)
-
Class
-
RADIUS_VENDOR_SPECIFIC
(int)
-
Vendor specific attribute
-
RADIUS_SESSION_TIMEOUT
(int)
-
Session timeout
-
RADIUS_IDLE_TIMEOUT
(int)
-
Idle timeout
-
RADIUS_TERMINATION_ACTION
(int)
-
Termination action
-
RADIUS_CALLED_STATION_ID
(int)
-
Called Station Id
-
RADIUS_CALLING_STATION_ID
(string)
-
Calling Station Id
-
RADIUS_NAS_IDENTIFIER
(int)
-
NAS ID
-
RADIUS_PROXY_STATE
(int)
-
Proxy State
-
RADIUS_LOGIN_LAT_SERVICE
(int)
-
Login LAT Service
-
RADIUS_LOGIN_LAT_NODE
(int)
-
Login LAT Node
-
RADIUS_LOGIN_LAT_GROUP
(int)
-
Login LAT Group
-
RADIUS_FRAMED_APPLETALK_LINK
(int)
-
Framed Appletalk Link
-
RADIUS_FRAMED_APPLETALK_NETWORK
(int)
-
Framed Appletalk Network
-
RADIUS_FRAMED_APPLETALK_ZONE
(int)
-
Framed Appletalk Zone
-
RADIUS_CHAP_CHALLENGE
(string)
-
Challenge
-
RADIUS_NAS_PORT_TYPE
(int)
-
NAS port type, one of:
- RADIUS_ASYNC
- RADIUS_SYNC
- RADIUS_ISDN_SYNC
- RADIUS_ISDN_ASYNC_V120
- RADIUS_ISDN_ASYNC_V110
- RADIUS_VIRTUAL
- RADIUS_PIAFS
- RADIUS_HDLC_CLEAR_CHANNEL
- RADIUS_X_25
- RADIUS_X_75
- RADIUS_G_3_FAX
- RADIUS_SDSL
- RADIUS_ADSL_CAP
- RADIUS_ADSL_DMT
- RADIUS_IDSL
- RADIUS_ETHERNET
- RADIUS_XDSL
- RADIUS_CABLE
- RADIUS_WIRELESS_OTHER
- RADIUS_WIRELESS_IEEE_802_11
-
RADIUS_PORT_LIMIT
(int)
-
Port Limit
-
RADIUS_LOGIN_LAT_PORT
(int)
-
Login LAT Port
-
RADIUS_CONNECT_INFO
(string)
-
Connect info
-
RADIUS_ACCT_STATUS_TYPE
(int)
-
Accounting status type, one of:
- RADIUS_START
- RADIUS_STOP
- RADIUS_ACCOUNTING_ON
- RADIUS_ACCOUNTING_OFF
-
RADIUS_ACCT_DELAY_TIME
(int)
-
Accounting delay time
-
RADIUS_ACCT_INPUT_OCTETS
(int)
-
Accounting input bytes
-
RADIUS_ACCT_OUTPUT_OCTETS
(int)
-
Accounting output bytes
-
RADIUS_ACCT_SESSION_ID
(int)
-
Accounting session ID
-
RADIUS_ACCT_AUTHENTIC
(int)
-
Accounting authentic, one of:
- RADIUS_AUTH_RADIUS
- RADIUS_AUTH_LOCAL
- RADIUS_AUTH_REMOTE
-
RADIUS_ACCT_SESSION_TIME
(int)
-
Accounting session time
-
RADIUS_ACCT_INPUT_PACKETS
(int)
-
Accounting input packets
-
RADIUS_ACCT_OUTPUT_PACKETS
(int)
-
Accounting output packets
-
RADIUS_ACCT_TERMINATE_CAUSE
(int)
-
Accounting terminate cause, one of:
- RADIUS_TERM_USER_REQUEST
- RADIUS_TERM_LOST_CARRIER
- RADIUS_TERM_LOST_SERVICE
- RADIUS_TERM_IDLE_TIMEOUT
- RADIUS_TERM_SESSION_TIMEOUT
- RADIUS_TERM_ADMIN_RESET
- RADIUS_TERM_ADMIN_REBOOT
- RADIUS_TERM_PORT_ERROR
- RADIUS_TERM_NAS_ERROR
- RADIUS_TERM_NAS_REQUEST
- RADIUS_TERM_NAS_REBOOT
- RADIUS_TERM_PORT_UNNEEDED
- RADIUS_TERM_PORT_PREEMPTED
- RADIUS_TERM_PORT_SUSPENDED
- RADIUS_TERM_SERVICE_UNAVAILABLE
- RADIUS_TERM_CALLBACK
- RADIUS_TERM_USER_ERROR
- RADIUS_TERM_HOST_REQUEST
-
RADIUS_ACCT_MULTI_SESSION_ID
(string)
-
Accounting multi session ID
-
RADIUS_ACCT_LINK_COUNT
(int)
-
Accounting link count
-
RADIUS_VENDOR_MICROSOFT
(int)
-
Microsoft specific vendor attributes (» RFC 2548), one of:
- RADIUS_MICROSOFT_MS_CHAP_RESPONSE
- RADIUS_MICROSOFT_MS_CHAP_ERROR
- RADIUS_MICROSOFT_MS_CHAP_PW_1
- RADIUS_MICROSOFT_MS_CHAP_PW_2
- RADIUS_MICROSOFT_MS_CHAP_LM_ENC_PW
- RADIUS_MICROSOFT_MS_CHAP_NT_ENC_PW
- RADIUS_MICROSOFT_MS_MPPE_ENCRYPTION_POLICY
- RADIUS_MICROSOFT_MS_MPPE_ENCRYPTION_TYPES
- RADIUS_MICROSOFT_MS_RAS_VENDOR
- RADIUS_MICROSOFT_MS_CHAP_DOMAIN
- RADIUS_MICROSOFT_MS_CHAP_CHALLENGE
- RADIUS_MICROSOFT_MS_CHAP_MPPE_KEYS
- RADIUS_MICROSOFT_MS_BAP_USAGE
- RADIUS_MICROSOFT_MS_LINK_UTILIZATION_THRESHOLD
- RADIUS_MICROSOFT_MS_LINK_DROP_TIME_LIMIT
- RADIUS_MICROSOFT_MS_MPPE_SEND_KEY
- RADIUS_MICROSOFT_MS_MPPE_RECV_KEY
- RADIUS_MICROSOFT_MS_RAS_VERSION
- RADIUS_MICROSOFT_MS_OLD_ARAP_PASSWORD
- RADIUS_MICROSOFT_MS_NEW_ARAP_PASSWORD
- RADIUS_MICROSOFT_MS_ARAP_PASSWORD_CHANGE_REASON
- RADIUS_MICROSOFT_MS_FILTER
- RADIUS_MICROSOFT_MS_ACCT_AUTH_TYPE
- RADIUS_MICROSOFT_MS_ACCT_EAP_TYPE
- RADIUS_MICROSOFT_MS_CHAP2_RESPONSE
- RADIUS_MICROSOFT_MS_CHAP2_SUCCESS
- RADIUS_MICROSOFT_MS_CHAP2_PW
- RADIUS_MICROSOFT_MS_PRIMARY_DNS_SERVER
- RADIUS_MICROSOFT_MS_SECONDARY_DNS_SERVER
- RADIUS_MICROSOFT_MS_PRIMARY_NBNS_SERVER
- RADIUS_MICROSOFT_MS_SECONDARY_NBNS_SERVER
- RADIUS_MICROSOFT_MS_ARAP_CHALLENGE
Quickstart
Howto start?
- get a radius resource
- configure the library
- create the request
- put attributes
- send the request
- receive attributes
- close the radius resource (optional)
Take also a look at the examples in this package.
The package contains an example php script. This script demonstrates howto
authenticate with radius using PAP or CHAP (md5). If you authenticate with
Microsoft Radius servers then its not possible to use CHAP (md5). If you
would like to authenticate with Microsoft Servers you have to use
MS-CHAPv1 or MS-CHAPv2, but its more complicated, because you need md4,
sha1 and des to generate the right data. The enclosed examples demonstrate
all authentication-methods, including MS-CHAPv1 and MS-CHAPv2. To get the
MS-CHAP to work you need the mcrypt and
the mhash extension, starting with
version 1.2 of the package, the mcrypt extension is no longer needed.