Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
HP-UX Virtual Partitions Administrator’s Guide > Chapter 5 vPars Monitor and Shell Commands

Shutting Down or Rebooting the nPartition (Or Rebooting the vPars Monitor)

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

To halt or reboot the hard partition gracefully, you need to do the following:

  1. Log into every virtual partition that is running and gracefully shutdown the partition via the HP-UX command shutdown.

    There is no command that shuts down all the virtual partitions at the same time. You need to shutdown every virtual partition one at a time.

    For our example, if all our partitions were up, we would need to shut them down:

    winona1# vparstatus winona1# shutdown -h winona2# vparstatus winona2# shutdown -h winona3# vparstatus winona3# shutdown -h
  2. After the last virtual partition is shut down, you will be at the vPars Monitor prompt (MON>) on the console.

    1. To reboot the hard partition, use the vPars Monitor command reboot:

      MON> reboot

    2. To shut down the rp5470/L3000 or rp7400/N4000 servers, access the GSP usingCtrl-B. You can then use the GSP command PC to power off the server. For example:

      MON> ^B GSP> PC

      Alternatively, you can power off the rp5470/L3000 or rp7400/N4000 servers via the physical power switch.

      Because no partitions are running and vPars Monitor is running only in memory, shutting down the vPars Monitor this way does not corrupt the server’s memory.

    3. To power off the cells assigned to the nPartition, access the GSP using Ctrl-B. You can then go to the Command Menu and use the command PE to power off the cells. For example:

      MON> ^B GSP MAIN MENU: CO: Consoles VFP: Virtual Front Panel CM: Command Menu CL: Console Logs SL: Show chassis Logs HE: Help X: Exit Connection GSP> cm Enter HE to get a list of available commands GSP:CM> PE This command controls power enable to a hardware device. B - Cabinet C - Cell I - IO Chassis Select Device: c Enter cabinet number: 0 Enter slot number: 6 The power state is ON for the Cell in Cabinet 0, Slot 6. In what state do you want the power? (ON/OFF) OFF GSP:CM>
      WARNING! Before modifying power settings and for detailed warnings and information on power for nPartitionable servers, read the section “Powering Cells and IO Chassis On and Off” in the manual nPartition Administrator’s Guide available at http://docs.hp.com.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2008 Hewlett-Packard Development Company, L.P.