Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
 HP-UX Virtual Partitions Administrator’s Guide > Chapter 4 Installing, Updating, or Removing vPars and Upgrading Servers with vPars

Updates Involving VPARSBASE
» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

VPARSBASE (the free demo product for HP-UX 11i v1) is no longer available or supported.

You can update directly only from free product to newer free product or from purchased product to newer purchased product. You cannot update directly from free product to the purchased product.

If you wish to update from the free product to the purchased product, first you need to remove the free product VPARSBASE, and then install the purchased product T1335AC for HP-UX 11i v1.

To avoid having to recreate your vPars configuration, you can perform the following steps:

  1. Backup the file /stand/vpdb (this file is the vPars partition database)

  2. Remove the free product from all virtual partitions. See “Removing the vPars Product”.

  3. Install the full product. See “Installing vPars with Ignite-UX on PA-RISC” or “Installing vPars with Software Distributor ”.

    However, while in standalone mode, at the point where you would normally create the virtual partitions using vparcreate, restore /stand/vpdb.

    Then continue with the installation as you normally would.



Upgrading Backplanes from PCI to PCI-X
  		 


Installing vPars with Ignite-UX on PA-RISC  
Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2008 Hewlett-Packard Development Company, L.P.