Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
Ignite-UX Administration Guide: for HP-UX 11i > Appendix A Troubleshooting

Installing from Media

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

DCE/RPC Errors

DCE / RPC errors (RPC exceptions) occur during the configuration stage, and a failure message is printed at the end of the installation.

There is an apparent problem with certain SD operations (for example, swacl) when only loopback networking is enabled. This would occur if the "media only" installation option is selected. The work-around is to install using the "media with networking enabled" option and set up (perhaps temporary) networking parameters: hostname, IP address, netmask, routing, etc. SD operations will complete normally.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© Hewlett-Packard Development Company, L.P.