Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
 Contact HP
More options
HP.com home
Ignite-UX Quick Start Guide: Create an Ignite-UX Server and Cold-Install Clients

Chapter 1 Setting up an Ignite-UX Server

 

Technical documentation

Complete book in PDF
Feedback
Content starts here

  Table of Contents

  Glossary

  Index

This chapter describes setting up an Ignite-UX server to cold install HP-UX 11i v1, v2, and v3 on clients over the network. You must have superuser privileges to set up an Ignite-UX server. You can stop anywhere in this procedure and resume where you left off at a later time.

This document assumes the network boot clients are on the same subnet as the Ignite-UX server. This document also assumes the network DHCP and DNS servers are already set up. These network services are vital to Ignite-UX server operation. If the Ignite-UX server is intended to support these network functions on an isolated subnet, the user should consult documentation that indicates how to set them up. Network services should be set up before the Ignite-UX server is set up. See http://www.docs.hp.com for networking documentation.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
2007, 2008 Hewlett-Packard Development Company, L.P.