Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
nPartition Administrator's Guide > Appendix A nPartition Commands

Specifying Remote Management Options to Commands

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

Two sets of remote management options are supported by the Enhanced nPartition Commands:

  • The -u... -h... set of options may be specified to cause the command to send its management request using WBEM to an nPartition other than the local nPartition (but can also be used as a "loopback access" to the local nPartition).

    NOTE: When specifying the -u... -h... options, the host specified by -h must be have the Enhanced nPartition Commands installed and have WBEM configured. Also, the client.pem file on the system from which the command is issued must have a copy of the SSL certificate entry (including the BEGIN and END lines) from specified host's server.pem file.

    See “Remote Management Using WBEM” for details.

  • The -g... -h... options may be specified to cause the command to send its management request using IPMI over LAN to a service processor in another server complex (but can also be used as a "loopback access" to the service processor in the local complex).

    NOTE: When specifying the -g... -h... options, the host specified by -h must have IPMI LAN access enabled. Also, the user who issues the command must correctly specify the host's IPMI password in order for the command to be able to successfully complete.

    See “Remote Management Using IPMI over LAN” for details.

The -u and -g options are mutually exclusive.

For more details about remote management, see “Remote and Local Management of nPartitions”.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2007 Hewlett-Packard Development Company, L.P.