Written Lab
407
Written Lab
Complete this lab by writing out the answers to the following questions.
1.
Write the command that enables multicast routing on a router.
2.
Write the commands that will enable PIM SM on interface
FastEthernet4/0.
3.
Write the configuration commands that will enable PIM DM on inter-
face FastEthernet3/0.
4.
Write the configuration for enabling PIM sparse-dense mode on inter-
face FastEthernet0/0.
5.
Write the command that will show you the multicast route table.
6.
Manually configure a router to be an RP using the IP address of
172.16.25.3 and apply access list number 30.
7.
Write the command that is used when implementing Auto-RP so that
the RP will announce only specific multicast groups. Use access list
number 10 and interface FastEthernet 4/0. Use a TTL value of 220.
8.
Write the command that enables an RP Mapping Agent. Use a TTL
value of 32.
9.
Apply a command that sets a TTL threshold of 235 on interface
FastEthernet 2/0.
10.
Write the commands that will enable CGMP on a router for interface
FastEthernet 3/0, and then write the command that will enable CGMP
on a switch.
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com