Page 39

Answers to Assessment Test

27.

B. The set command set int sc0 vlan# changes the default VLAN
for the supervisor module to the specified VLAN. See Chapter 2 for
more information.

28.

C. The switch will flood the network with the frame looking for the
device. For more information on LAN switching, see Chapter 4.

29.

A. Adding the PIM configuration to the interface enables only Inter-
net Group Management Protocol (IGMP) in addition to PIM. Auto-RP
and Cisco Group Management Protocol (CGMP) must be configured
separately. See Chapter 10 for more information.

30.

A, C, D. The Multilayer Switching Switching Engine (MLS-SE)
needs to know three things to create an entry: the Multilayer Switch-
ing Route Processor (MLS-RP), a candidate packet, and an enable
packet. See Chapter 7 for more information.

31.

C. VLAN 1 is a default VLAN and used for management by default.
See Chapter 5 for more information.

32.

A, D. Physical security of switches is one of the most important
access policies you can create at the access layer. Stopping users from
plugging into any port on a switch is part of port security. See Chapter 11
for more information on access policies.

33.

C. The 2926G is not capable of handling an internal route processor.
See Chapter 1 for more information regarding the 2926G switch.

34.

C. Due to the prefix length and the high order bit already in use in the
multicast MAC address, only 23 bits are left for mapping. See Chapter 9
for more information.

35.

B. The command to set the enable password on a 1900 switch is
enable password level 15 password

. See Chapter 2 for more

information.

36.

B. The Cisco proprietary protocol Per-VLAN Spanning Tree (PVST)
uses a separate instance of spanning tree for each and every VLAN.
See Chapter 5 for more information.

www.sybex.com