332
Chapter 8
Hot Standby Routing Protocol (HSRP)
5.
What is the default priority of an HSRP router?
A.
10
B.
100
C.
1000
D.
1
6.
Which of the following commands is correct for assigning interface
ethernet 0 to HSRP group 3?
A.
router(config)#standby 3 1.1.1.1
B.
router(config-if)#standby 3 1.1.1.1
C.
router(config)#standby 3 ip 1.1.1.1
D.
router(config-if)#standby 3 ip 1.1.1.1
7.
If you are running HSRP on FastEthernet 0/1 and you want to monitor
serial 0, which is on the same router but is not running HSRP, which
of the following commands will allow the router to drop the priority
on the HSRP router so that the serial interface can be used on the
standby router if serial 0 drops on the active router?
A.
standby f0/0 to s0
B.
standby 1 track serial 0 50
C.
standby f0/0 serial 0 55
D.
standby s0 f0/0 50
8.
If you want to change the priority of an HSRP interface from the
default to 110, which of the following commands would you use?
A.
standby 1 priority 110
B.
standby priority group 110
C.
standby group priority 110
D.
int e0, group priority 110
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com