324
Chapter 8
Hot Standby Routing Protocol (HSRP)
Written Lab
Complete this lab by writing out the answers to the following questions:
1.
Write the command that will allow you to view the table that holds the
IP-to-MAC addresses resolved on a router.
2.
Write the command to enable HSRP on an FE0/0 interface using a
group number of 2, IP address of 1.1.1.1.
3.
Write the command that will force an election if a new router joins the
HSRP group 2 with a higher priority than the active router.
4.
Write the command to change the priority to 110.
5.
Write the command to set the router to track serial 0 and set the router
priority to decrement by 50 if it fails.
6.
Write the command to view the virtual address of an HSRP group.
7.
What command can you type on the router to view the hellos being
sent and received on an HSRP interface?
8.
The router enters the ___________________ state after it hears from
the active router and knows the virtual IP address.
9.
This state means the router will become the active router if the active
router fails.
10.
The default priority on a router is ___________________ .
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com