244
Chapter 6
Inter-VLAN Routing
9.
Configure the FastEthernet connection to the 5000 series switch to be
full duplex.
1900B(config)#int f0/26
1900B(config-if)#duplex full
1900B(config-if)#int f0/27
1900B(config-if)#duplex full
10.
Set the ports to configure an EtherChannel bundle when the 5000
series is configured. This can be run only on the supervisor card or a
specific EtherChannel card. EtherChannel will be run only on the
1900B connection to the 5000 switch.
1900B(config-if)#port-channel mode on
Configuring the 5000 Series Switch
1.
Connect your console cable to the 5000 series switch and press Enter.
Press Enter at the password prompt, then again at the password
prompt, type enable and press Enter.
2.
Set the hostname of the switch.
#(enable)set prompt Cat5000>
3.
Set the usermode and privilege mode passwords.
Cat5000>(enable)set password [press enter]
Enter old password: [press enter]
Enter new password: [this doesn't show]
Retype new password: [this doesn't show]
Password changed.
Cat5000> (enable)set enablepass
Enter old password:[press enter]
Enter new password: [this doesn't show]
Retype new password: [this doesn't shoow]
Password changed.
Cat5000> (enable)
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com