Connecting and Logging In to a Switch
67
Press K to enter CLI mode, and then enter enable mode and global con-
figuration mode by using the config t command:
1 user(s) now active on Management Console.
User Interface Menu
[M] Menus
[K] Command Line
[I] IP Configuration
Enter Selection: K
CLI session with the switch is open.
To end the CLI session, enter [Exit].
#config t
Enter configuration commands, one per line. End with
CNTL/Z
(config)#enable password ?
level Set exec level password
(config)#enable password level ?
<1-15> Level number
To enter the usermode password, use level number 1. To enter the enable
mode password, use level mode 15:
(config)#enable password level 1 todd
(config)#enable password level 15 sanfran
(config)#enable secret cisco
(config)#exit
#exit
CLI session with the switch is now closed.
Press any key to continue.
Catalyst 1900 Management Console
Copyright (c) Cisco Systems, Inc. 1993-1998
All rights reserved.
Enterprise Edition Software
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com