64
Chapter 2
Connecting the Switch Block
a Console > prompt. At this point, you can enter enable mode and configure
the switch using set commands:
BOOTROM Version 5.1(2), Dated Apr 26 1999 10:41:04
BOOT date: 08/02/02 BOOT time: 08:49:03
Uncompressing NMP image. This will take a minute...
Downloading epld sram device please wait ...
Programming successful for Altera 10K10 SRAM EPLD
Updating epld flash version from 0000 to 0600
Cisco Systems Console
Enter password: [press return here]
1997 Mar 22 22:22:56 %SYS-5-MOD_OK:Module 1 is online
1997 Mar 22 22:23:06 %SYS-5-MOD_OK:Module 2 is online
Console>
1900 Switch Startup
When you connect to the 1900 console, the menu below appears. By pressing
K, you can use the command-line interface, and M will allow you to config-
ure the switch through a menu system. The I option allows you to configure
the IP configuration of the switch (this can also be accomplished through the
menu or CLI at any time). Once the IP configuration is set, the I selection no
longer appears:
1 user(s) now active on Management Console.
User Interface Menu
[M] Menus
[K] Command Line
[I] IP Configuration
Enter Selection: K
CLI session with the switch is open.
To end the CLI session, enter [Exit].
>
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com