Page 308

282 Chapter 9: Frame Relay Connection Controlling Traffic Flow

Users have reported issues with network reachability. What command could be utilized to
view the status of PVCs?

______________________________________________________________________

Write out a basic Frame Relay configuration including two point-to-point subinterfaces
off of Serial 0, using IP only. The DLCI for Serial 0.1 should be 24 and for Serial 0.2, the
DLCI should be 95.

______________________________________________________________________

Create the same configuration from Question 18, but use multipoint interfaces instead.

______________________________________________________________________

Once the router has decreased throughput due to BECN requests, how long must it wait
prior to increasing throughput once again?

______________________________________________________________________

Increasing throughput once every 16 time intervals can mean that some time passes before
CIR speed is regained. How can the router be configured to force the speed back to CIR
immediately after the congestion has cleared?

______________________________________________________________________

What happens to LMI traffic if the command no keepalive is issued on the router
interface?

______________________________________________________________________