687
Command
Description
Chapter(s)
show appletalk zone
Displays the zone names and networks
that are known to the router through ZIP
updates.
10
show arp
Displays the contents of the ARP table as
well as status.
4, 5
show arp
Displays the ARP information for the
router.
11
show bridge {vlan number}
Shows which bridging encapsulations are
enabled.
11
show buffers
Displays buffer statistics for the router.
4, 7
show cam
Reports the MAC address associated
with the ports of the switch. These
addresses are stored in the CAM table;
this command accesses that table.
11
show cdp
Displays the Cisco neighbors.
11
show config
Similar to the show running-config
command on Cisco routers. Provides all
configuration settings on the switch for
all modules, with a few exceptions for
certain modules such as the RSM (Route
Switch Module).
11
show controller bri
Displays the interface status and the
superframe error counter.
8
show controllers cbus
Displays the buffer information on line
cards connected to the cbus.
4
show controllers serial
Shows specific hardware information
regarding the serial controller.
7
show dhcp servers
Shows information regarding the DHCP
servers.
6
show dialer
Reports information regarding the DDR
connections, including the number dialed,
the success of the connection, the idle timers
that control the duration of a DDR
connection without data packets, and the
number of calls that were screened or
rejected due to administrative policy.
8
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com