564
Chapter 11
Troubleshooting Switched Ethernet
show rif Show Routing Information Field
(RIF)Table
show rsmautostate Show RSM derived interface state
enabled/disabled
show snmp Show SNMP information
show span Show switch port analyzer information
show spantree Show spantree information
show station Show Tokenring Station info
show summertime Show state of summertime information
show system Show system information
show tacacs Show TACACS information
show test Show results of diagnostic tests
show time Show time of day
show timezone Show the current timezone offset
show tokenring Show tokenring information
show trunk Show trunk ports
show users Show active Admin sessions
show version Show version information
show vlan Show Virtual LAN information
show vmps Show VMPS information
show vtp Show VTP information
show system
The
show system
command provides high-level summary information
regarding the switch, including the status of power supplies, uptime and
administrative settings, and the percentage of traffic on the backplane.
Switch_A> (enable)
show system
PS1-Status PS2-Status Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- ---------- ---------- -------------- ---------
ok ok ok off ok 153,19:29:57 none
PS1-Type PS2-Type Modem Baud Traffic Peak Peak-Time
---------- ---------- ------- ----- ------- ---- -------------------------
WS-C5008B WS-C5008B disable 9600 0% 0% Tue Feb 22 2000, 12:14:38
System Name System Location System Contact
------------- ------------------------ --------------------
Switch_A Maui, Hawaii Robert Padjen
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com