Laboratory Exercise
511
Laboratory Exercise
In this exercise, three routers will be connected via their Ethernet inter-
faces. Configure the routers with the following commands to set up NLSP.
Figure 9.2 illustrates the connections.
F I G U R E 9 . 2
Network configuration for the NLSP laboratory
Router_A#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router_A(config)#ipx routing
Router_A(config)#ipx internal-network A
Router_A(config)#int e0
Router_A(config-if)#ipx network 1
Router_A(config-if)#ipx nlsp enable
Router_A(config-if)#^Z
Router_A#wr t
Router_B#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router_B(config)#ipx routing
Router_B(config)#ipx internal-network B
Router_B(config)#int e0
Router_B(config-if)#ipx network 1
Router_B(config-if)#ipx nlsp enable
Router_B(config-if)#int e1
Router_B(config-if)#ipx network 2
Router_B(config-if)#ipx nlsp enable
Router_B(config-if)#^Z
Router_B#wr t
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com