486
Chapter 9
Troubleshooting Novell Connectivity
Sending 5, 100-byte IPX cisco Echoes to
200.0000.30c0.9690, timeout is 2 seconds
:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max
= 16/20/32 ms
In the following example, the Novell Standard Echo option and
verbose
were selected by using the extended commands:
Router_A#ping
Protocol [ip]: ipx
Target IPX address: 200.0000.30c0.9690
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Verbose [n]: y
Novell Standard Echo [n]: y
Type escape sequence to abort.
Sending 5, 100-byte IPX Novell Echoes to
200.0000.30c0.9690, timeout is 2 seconds:
0 in 20 ms
1 in 20 ms
2 in 20 ms
3 in 16 ms
4 in 20 ms
Success rate is 100 percent (5/5), round-trip min/avg/max
= 16/19/20 ms
show Commands
The Cisco router's show commands provide a great deal of information
regarding IPX. This output is available from the show ipx ? command. As
presented in Table 9.2, the show ipx command provides information
regarding routing and routing protocols, in addition to NetWare servers.
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com