background image
Debugging ISDN
449
BRI0:2 - dialer type = ISDN
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is idle
show ppp multilink
Multilink is an extended portion of the point-to-point protocol. As shown in
the following, the service is configured with the ppp multilink bap and
ppp bap
commands (italicized below).
interface BRI0
ip address 10.1.1.2 255.255.255.0
no ip directed-broadcast
encapsulation ppp
dialer map ip 10.1.1.1 name Top broadcast 18008358661
dialer-group 1
isdn switch-type basic-ni
isdn spid1 0835866201
isdn spid2 0835866401
ppp multilink bap
ppp bap call accept
ppp bap timeout pending 20
hold-queue 75 in
Debugging ISDN
T
he debug commands in ISDN are extremely helpful for researching prob-
lem causes and resolving them. This section addresses the commands and provides
some useful methods for employing them, and attempts to provide scenarios
where such commands may be needed.
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com