244
Chapter 5
Applying Cisco's Diagnostic Tools
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored,
0 abort
0 input packets with dribble condition detected
250 packets output, 15309 bytes, 0 underruns
250 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
250 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped
out
Router_A#
The following outputs are from the
show interface Ethernet 0/1
and
show interface Serial 0/0
commands, respectively:
Ethernet0/1 is up, line protocol is up
Hardware is AmdP2, address is 0010.7bd9.2881 (bia
0010.7bd9.2881)
Internet address is 172.16.20.5/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely
128/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10
sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:02, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 983450 bits/sec, 875 packets/sec
5 minute output rate 435097 bits/sec, 357 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com