xl
Assessment Test
21.
What are the valid LMI types? (Choose all that apply.)
A.
LMI
B.
Cisco
C.
ITU-T
D.
ANSI
22.
When is a "default gateway" used on the router? See Chapter 6.
A.
When a packet leaves the router
B.
When no route exists in the route table
C.
When a static route has been set
D.
Only when the router is in boot mode
23.
What are the valid Frame Relay encapsulation types? (Choose all
that apply)
A.
IETF
B.
ITU-T
C.
Cisco
D.
ANSI
24.
What do the following lines of router output indicate? (Choose all
that apply.)
Router_A#show interface to0
... some output deleted ...
MTU 4464 bytes, BW 16000 Kbit, DLY 630 usec, rely
255/255, load 1/255
Encapsulation SNAP, loopback not set, keepalive set
(10 sec)
ARP type: SNAP, ARP Timeout 04:00:00
Ring speed: 16 Mbps
... output removed ...
Last clearing of "show interface" counters never
Copyright ©2000 SYBEX , Inc., Alameda, CA
www.sybex.com