654
Appendix B
Configuring the Catalyst 1900 Switch
16.
A, C, D. The three ways to configure a port on the 1900 switch
are through the Virtual Switch Manager, the menu system, and the
command-line interface.
17.
D. The command to set the switch name is hostname (one word).
18.
A, C, D, G. CDP is enabled, no IP address or default gateway is
set, the switching mode is FragmentFree, the 10BaseT ports are half
duplex, the Fast Ethernet ports are auto-negotiate duplex mode, span-
ning tree is enabled, and no console password is set.
19.
B. The switch uses the type slot/port command. The first 24 ports
are Ethernet, and ports 26 and 27 are Fast Ethernet.
20.
D. The switch uses the type slot/port command. The first 24 ports
are Ethernet, and ports 26 and 27 are Fast Ethernet.
21.
A. To allow only a certain number of MAC addresses to be assigned
to a port, use the port secure max-mac-count count command. The
default is 132.
22.
C. To set a permanent MAC address on an interface, use the mac-
address-table
permanent mac-address interface command.
23.
D. To allow only port e0/5 to communicate via the hardware address
attached to port e0/2, use the mac-address-table restricted
static
mac-address dest-interface source-interface
command.
Copyright ©2002 SYBEX, Inc., Alameda, CA
www.sybex.com